Taper Turning and Boring Lathe Rig

| View Cart ⇗ | Info

“Where the lathe has no special taper turning attachment, the rig here described can readily be made and applied. The hand wheel of the cross feed is removed, and replaced by a hard—wood disk S that has a rim groove for a stout cord A. One end of this cord is attached to the tail stock at B, by means of a bent metal strip D. The conicity or degree of taper will be determined by the diameter of the disk S.” —Grimshaw, 1902

Source

Grimshaw, Robert Modern Workshop Hints (Philadelphia, PA: Sampson Low Marston & Company LTD, 1902)

Downloads

TIFF (full resolution)

2400×780, 254.6 KiB

Large GIF

1024×332, 45.6 KiB

Medium GIF

640×208, 24.0 KiB

Small GIF

320×104, 8.7 KiB